I have the probe and nozzle set to center but when I run a bed level 5×5, it starts more offset (closer) to the left edge of the bed and it starts so close to the front of the bed that it touches the clip. Is there a way to change the start position of the bed leveling to get it centered to the bed?
I’m not exactly sure where in Cura I could change those offset settings. I run the bed leveling using the screen on the printer. Could you point me in the right direction?
I have been using your firmware for a while, but I have a direct drive with an all metal hot end. Can you make this firmware but just bump the temp limits up for people with an all metal hot end? Thank you!
https://github.com/mriscoc/Ender3V2S1/releases/tag/20220527
try professional firmware,
A new custom G-code C104 U1 T### to unlock the hotend maximum temperature to ###°C (CAUTION)