eSun eClean Filament 0.1Kg 1.75mm

Sometimes, you just wanted to clean up your nozzle without tinkering around with your machine. Some nozzle is expensive and hard to clean. throwing it off would be wasted. Here’s cleaning filament come to rescue!

This cleaning would be more obvious when you are changing to different type of filament.
It has certain adhesion ability to ABS, PLA, carbon, etc. It can bring out the remaining materials remaining in the nozzle and directly remove the material residue and carbon deposit in the printer;

Poor quality or cooked/burned filament can leave residue in your nozzle. Even PLA can solidify in the nozzle over time, so we advise flushing it through at least every 200 – 400 printing hours.

Keep the printing temperature the same as your printing filament and begin to extrude the new cleaner material into thin air (don’t try to print with it!). Keep extruding until you cannot see residue of the previous material, or contamination specks. Once it runs clear, simply unload and reload with your printing filament.
Product Features:
1.Excellent heat stability, Wide cleaning temperature range cleaning rods extrude normally at the temperature range of 150℃-260℃when testing.
2.With slightly viscosity and enable it to take residual material out of nozzle and no jamming in nozzle
3.Not easy to degradation in the heat.
4.Using cleaning rods can prevent nozzle plugging during transition between high and low temperature material.

Pros:
Efficient cleaning
Minimal cleanup
Minimal mechanical load on printer parts

Cons:
Additional expense
Only works on partial clogs

What you need to know about Cleaning Filament:
https://all3dp.com/2/3d-printer-cleaning-filament-what-you-need-to-know/

Packaging List:
eSun eClean 0.1Kg 1.75mm x 1