Mosquito Hotend Cloned E3D V6 Titanium Nozzle 24V Fan for Ender 3 CR10 Titan/BMG Extruder

SKU: 9412225744




Note: This is high flow version which is much compatible for nozzle above 0.4mm, where standard flow is for better for 0.4mm and below.

Once you received the hotend, do double check if everything is screw tight to prevent unwanted filament leaking during printing process.

If you already using E3D Hotend, direct replacement, otherwise for Ender 3 series,
There are a few recommended mount: (Simple Bowden Mount) (Lightweight Direct Drive, Require lots of changes)

Superior heat break performance
– The heat break conducts 85% less heat into the heat sink than a typical threaded heat break
– Steep temperature gradient at the heat break, and high tolerances along the filament path allow for better transmission of fine motor movements, resulting in beautiful, higher resolution prints
– Steep temperature gradient at the heat break reduces the likelihood of jamming
– Reduced heat transmission removes the need for a large heat sink
– Composite construction of the bimetallic heat breakā„¢ allows for the use of materials optimized for heat transfer in each section of the heat break
– Allows for hotend to be mounted with a printed, plastic adapter, without raising safety concerns

Increased structural rigidity
– The heat break has been separated from the structural components of the hotend, allowing for a heat break that is not load bearing, and can be very thin walled. This allows for a reliable, rigid exterior structure
– No components are prone to loosening at the mounting points
– Nozzles can be changed with one hand, without grasping the hot block
– In the case of a severe crash, an entirely new hotend is not necessary, parts can be easily swapped out

Larger temperature operating range
– Specially-engineered high temperature copper alloy in the hot block will not soften at high temperatures in excess of 550C.
– Threads in the hot block will not deform at high temps, allowing removal of nozzles even after multiple high temp heat cycles
– Nickel plating on the hot block reduces radiative heat loss and prevents galling of threads

Modular/adaptable to almost any FFF/FDM printer
– Compact, flat, ambidextrous form factor
– 5 different hole mounting patterns to allow for adaptation to virtually any printer
– Printable adapters can be created to diversify mounting options

Ideal for multiple extrusion systems
– Small form factor and light mass allows for back-to-back mounting with small nozzle-nozzle distance

– Small mass allows for more rapid motion
– Less reinforcement needed for the motors, belts, and drives in the motion system

Packaging List:
High Flow Version Mosquito Hotend Kit Clone (Including 24v Fan) by TwoTrees or
Standard Flow Mosquito Hotend Cloned (Fan not included)

Reviews (0)


Be the first to review “Mosquito Hotend Cloned E3D V6 Titanium Nozzle 24V Fan for Ender 3 CR10 Titan/BMG Extruder”

There are no reviews yet.

Select your currency
USD United States (US) dollar