Noctua NF-A6x25 FLX 12V (60x25mm)

*Ready stock ship within 24 hours from KL Sungai Besi area*

*Applies to Klang Valley buyers only. Whatsapp us @ ZeroOneOne-10800321 if you need urgent same day delivery (eg. Grab) or self pick-up. Buyers will have to bear the delivery cost and set our Sungai Besi office as pick up point. Do check with us before you purchase as we may not be available.

Premium quiet fan, 60x60x25 mm, 12V, 3-pin Molex, 3000/2400/1600 RPM, max. 19.3 dB(A), >150,000 h MTTF
We have FLX version

3-pin FLX version provides 3000/2400/1600rpm speed settings via Low-Noise Adaptors to fine-tune the fan for maximum airflow or near-silent operation

FLX are 3 pins fan while PWM has 4pins. The extra pin in PWM version is for you to control the speed via board programatically. If you are using for 3D PRINTER, we advise you to go for FLX as it is recommended by most guides out there. Please note that you will need a buck converter if you are running it on 24v printers.

*Note for 3D Printer: This Fan is is thicker than the stock in Meanwell Power supply for Ender 3 Pro. you have to externally mount it. The voltage of the Meanwell is can be 12V or 24V, so check if buck converter is needed. However you need to change the 3-pin connector to a 2-pin connector, which require jumper wire. Use a hot glue gun to glue two female ends of the jumper wires together to create a 2-pin plug, then plugged in the male side of the wires into the 3-pin connector, matching red with positive, black with negative.

Please note that this is a size 6025 fan. If you are looking for size 4010, Check it out Noctua NF-A4x10 FLX . Stay tuned!

Package includes:
Noctua 6025 x1 (FLX)
Buck Converter x1 (LM2596 DC-DC Adjustable Step Down Voltage Converter)