First layer is essential to get the your print stick to the bed or even prevent failures in later print. Many people do not give enough attention to get the right first layer. Once you do that, many of your problems will soon disappear and no longer waste filaments and have fun in 3d printing. […]
Photocuring (SLA/DLP/LCD) 3D printing is very easy to get started & able to create very fine details & complex geometric shapes. Although this technology has many advantages, your print may still fail or rough if you are not very familiar with slicing, printing skills, etc. Below explains how to improve the quality of 3D Resin […]
What causes Filament Grinding & Stop Extruding mid print? Most 3D printers uses one of two small drive gear to grabs the filament and pressed it against another bearing. The drive gear has sharp teeth that allow it to bite into the filament and push it forward or backward, depending on which direction the gear […]
Congratulation for becoming a CR-10 Smart owner. This is an amazing medium size of CR-6 SE with remote printing & much sturdy build. Despite the amazing features of the machine, unfortunately the QC wasn’t done right & firmware wasn’t really ready yet. Fortunately the CR-10 Smart is a very simple machine to assemble and if […]